Aquaseal¨ Urethane Repair Adhesive Sealant
|DIRECTIONS FOR NEOPRENE REPAIR:|
Clean damaged area with Cotol-240ª Cure Accelerator/Precleaner or solvent (paint thinner, nail polish remover or similar). Trim loose threads. Non-fabric surfaces should be roughened with sandpaper, then cleaned. Apply Aquaseal? to surfaces directly from tube or with knife or flat stick. Keep repair level overnight. Avoid contact with other surfaces. Most repairs reach full strength overnight (10-14 hours). Allow longer for thickest repairs. For fastest cure (2 hours or less), mix in Cotol-240.
HOLES AND TEARS: Create backing with removable tape. Fill void and 1/4 beyond edge with Aquaseal. Remove tape after full cure.
SEAMS: Apply 1/16 thick bead overlapping seams edges by at least 1/4. Apply with slight pressure to saturate fabric surfaces.
HIGH WEAR AREAS: Apply thin coat with knife for flexible abrasion resistance.
WARNING: FULLY CURED AQUASEAL IS SLIPPERY WHEN WET. For added traction on footwear, sprinkle sand on uncured Aquaseal 1/2 hour after applying.
CLEAN UP: To remove Aquaseal from hands, buff with cloth soaked in paint thinner, nail polish remover or 99% isopropyl alcohol.
STORAGE: Advance contents to tube neck. Wipe clean and cap. Keep in cool, dry place; for extended life, place in freezer. To thaw or for easier-flowing contents, soak tube in warm water for 15 minutes.
<li>2 small tubes</li>
<li>Sealing small leaks</li>
<li>Sealing seams and seals</li>
Having an account with us will allow you to check out faster in the future, store multiple addresses, view and track your orders in your account, and more.Register