Cotol-240ª Cleaner Cure Acceleratoris a urethane cure accelerator and pre-cleaner to be used in conjunction with Aquaseal¨or . The solvent cleans and prepares the surface, readying it for Aquaseal¨ , speeding the tack time to 15 minutes and the full cure time to less than two hours. Cotol-240 is also ideal for removing tar, sap, glue, and other resins from various surfaces including glass, plastic and metal. Available in 1/2 oz. Blister Pack, 4 oz. and Quart (not shown).

Cotol-240ª Directions for usewith Aquaseal¨  Urethane Repair Adhesive and Sealant:

AS PRECLEANER:

Apply a small amount to the damaged area (spot test for colorfastness). Rub with a clean cloth until dry. Repeat steps 1 and 2. Apply Aquaseal as directed.
Note: for best adhesion, first roughen non-fabric surfaces with sandpaper.

AS CURE ACCELERATOR:

Thoroughly mix 1 part cure accelerator with 3-4 parts Aquaseal¨or using a stick, toothpick, or knife. Mix on a non-absorbent surface such as a plastic lid or plate. Immediately apply the mixture to the damaged area. Allow the repair to completely cure at least 2 hours before using.

FOR COLORS: Mix food coloring or paint colorant (available at paint stores) into the Aquasure and cure accelerator before applying.

CLEAN-UP: To remove Aquaseal¨  from hands, use cloth soaked with paint thinner, nail polish remover or 99% isopropyl alcohol.

STORAGE: Cap tightly. Store in cool, dry place. Use blister card package for storage